Even though we reside in the mountain desert of Albuquerque, New Mexico, it still gets chilly during the winter, so we need to ensure that our furnace is in good working order. The worst possible scenario is when the heating system fails on the day with the lowest temperature of the year. It’s comforting to know that regular furnace maintenance can help you prevent breakdowns in the middle of winter. Still, it’s important to remember that even the most meticulously kept furnaces can fail.

Things You Should Do if Your Furnace Breaks Down

1.      If you smell natural gas, you should leave the area immediately.

Before you attempt to find a solution to the issue, check to see that nobody is in danger. Because natural gas does not have an odour and cannot be seen, a chemical known as mercaptan is added to it so that humans may detect it. The odour of natural gas is easily recognizable and will serve as an early warning sign. The odour reminds one of the stale eggs or rotten eggs. Turning the lights on or off can cause small electrical arcs, which can cause the gas to ignite; thus, you should not do this and not put the stove on. On the way out of the house, you should throw open all windows that are accessible to you. Phone calls should be avoided inside the house, and the vehicle should be parked in the garage. Do not ignite it since doing so can result in an explosion.

2.     Investigate other risk-free methods of warming your house.

Find ways to keep warm until the furnace can be fixed after you have determined that there are no gas leaks in the home and that you are safe to remain there. If you cannot, you will likely be required to get an alternative place to reside. Electric heaters and heat from a fireplace are risk-free methods of heating your house.

3.     After attempting a few problematic steps, contact customer care.

Check whether the fuse that protects the appliance has blown or if the pilot light has gone out; both problems are easy to remedy on your own. Call for assistance if you need more confidence in completing the task.

4.     Take measures to prevent the pipes from freezing.

While you wait for the repair to be finished, you will need to drain the water pipes and ensure that the main plumbing line is heated to a temperature higher than 32 degrees using a portable heater.

5.     Make sure the warm air stays inside the house.

Maintain the closed state of all the doors, windows, and drapes. Because of this, none of the heat still in the house will be allowed to escape.

Concern for One’s Own Safety Should Come First When Attempting to Repair a Furnace

Fixing a furnace can be a time-consuming process at times. When your heating system suddenly stops working, there are some things you need to avoid doing at all costs. It would help if you did not try to heat your home using your oven. It is unsafe to bring heaters intended for outdoor use into the house. This covers things like propane, kerosene, and gasoline, among other things. Never attempt to address severe faults with the furnace on your own. This may save you money in the short term, but in the long run, it will probably make the problem worse, resulting in you having to spend more than the cost of a simple repair call would have been. You must know what you are doing to avoid causing significant damage.

Albuquerque gas furnace inspection, diagnosis, repair, replacement, maintenance, and other services are available in a wide range of serviceable areas, including Rio Rancho, Placitas, Corrales, Bernalillo, North Albuquerque, Albuquerque South Valley, Bosque Farms, Isleta, Edgewood, Tijeras, Sandia, North Albuquerque, and the Greater Albuquerque Metro-Area.

It would help if you got in touch with the trained technicians at Day and Night Plumbing, Heating and Cooling to find out about the issue and get it resolved ASAP. Albuquerque furnace repair is one of the company’s primary area of expertise.  This will ensure that your comfort levels return to normal as quickly as possible. Because we have the necessary equipment and years of expertise, we can execute the necessary repairs in a snap!